• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Envision 375 cut registration issue

C

Clifford

New Member
I recently purchased a newer 375. On repeat cuts, it starts out spot on for the first row or two, but the further it goes, the cuts get farther off to the right. It has up to date firmware, and I calibrated it but still having issues. It will cut a single decal just fine. I tried doing the repeats in the GSPlot6.0 as well as in Omega (ver 6.0) and sent the job as a group but get the same results. Anyone have any suggestions?
 
You must log in or register to reply here.
Top