tandem signs
New Member
Ok so I came in on Monday after the weekend and my machine was beeping and showing the OverCurrent error message which I've had a few times. I cleaned the encoder strip and 'zeroed' out the print carriage which usually solves this for me. Turned the print back on and got the Wiper Error message. Cleaned that and the sensors in and around the print carriage. Turned it back on and got a Cap Error message. So after that I cleaned the entire capping station and replaced some wipers. Guess what happens now??? It basically seems the print is stuck in a 'loop' with these three messages and I have no clue what to do. Any suggestions?!?! Thanks in advance!