Falcon Jr. Wiper Problem

[Finishline Signs]

I just installed a new maintenance station in my Falcon Jr. Everything worked fine after I got finished but when it completes a cleanning cycle it leaves the wiper in the out position instead of drawing it in. Any one have any ideas of whay might be causing this.

Stuart

 

[SlightlyChilled]

you might have it in back words or it's popping out on the bottom. Give it a good look. The rubber might not be sitting right

 

[Finishline Signs]

It's not the wiper itself. The arm that the wiper is in is what is staying out where the heads go over it. During the clean cycle it move in and out to wipe the head like it should but it stays in the out position when it's done causing the heads to rub over it. I have to move it in myself so it doesn't rub the heads every time they go over it.

 

[AUTO-FX]

That happened with mine when I replaced maintenance station. Try lubricant. I used teflon.

 

[Finishline Signs]

Thanks I'll try that.

 

[SlightlyChilled]

does it stay out 100% or does it more like 10% then stop?
try the lube and let us know