Gerber Egde Prints contor cut with roland? is this possible?

[92zero Designs]

Hey Everyone.

I have a Gerber Edge and a Gerber gs15 Plotter. I also have a Roland Versacamm sp300v.

The Gerber Plotter is old/slow and is always a headache when using it.

The Question is- Is it possible to Print with my Edge and Cut the prints with my Roland?If so how?

I use Omega with my Gerber and Flexi Sign with my Roland.

Thanks.

 

[Jburns]

I used to do that with my edge and graphtec thru Flexi- but issue is less print area due to crop marks

 

[92zero Designs]

How did you do it? That would be fine with less print area

 

[Jburns]

Open your rip and print when ready to print- assign your Roland as the contour cutter. And also assign crop marks
then make sure your Roland is checked in production manager.
the job will s be to both your printer and cutter - print first- then open production manager to contour- just like you did with the Gerber cutter
(this done in Flexi)