JamieInReynoldsburg
New Member
I'm really not so much a newbie, as haven't been here in a long time, and not with this account.
Anyway, trying to install a brand new Graphtec Cutting Pro FC9000-160 for use in Gerber Omega 6.5. And it's networked directly (IP 192.168.0.1). I'm an old hand at networking plotters in Omega, I've used it since it was Graphix Advantage in the 1990s. But I've always gone through GSPQueue, and always with the plotter attached to a physical computer. AND (maybe the hardest part) using a plotter that is IN Gerber's list. The closest one in the pre-installed plotter drivers is FC8600-160.
Help would be greatly appreciated, and apologies if this isn't in the right place. Thanks! --Jamie in Reynoldsburg
Anyway, trying to install a brand new Graphtec Cutting Pro FC9000-160 for use in Gerber Omega 6.5. And it's networked directly (IP 192.168.0.1). I'm an old hand at networking plotters in Omega, I've used it since it was Graphix Advantage in the 1990s. But I've always gone through GSPQueue, and always with the plotter attached to a physical computer. AND (maybe the hardest part) using a plotter that is IN Gerber's list. The closest one in the pre-installed plotter drivers is FC8600-160.
Help would be greatly appreciated, and apologies if this isn't in the right place. Thanks! --Jamie in Reynoldsburg