Bigcat_hunter
New Member
What should I set the heaters at for banner material? I have it set for vinyl but the ink looks blotchy on banner. I know I need to increase it but don't know to what temps.
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Heater settings for banner material?
- Thread starter Bigcat_hunter
- Start date
J Hill Designs
New Member
I run banner at 20 pre, 30 print, and 50 post
Bigcat_hunter
New Member
Thanks I'll give that a shot and se what it does.
J
john1
Guest
I have a Roland but on banner material if your heats too high it will cause head strikes (the material will bunch up). Just be careful and make sure you clean your heads after banner printing. I always notice drips (dots) when printing after a few banners from the banner fibers getting onto the heads.