How do I change conditions ?

[Drip Dry]

OK, I know I've done this before, but now I think maybe I was dreaming.

I'm using a fc7000

I started cutting a job, and realized it was cutting too deep. I want to change the pressure and not abort the whole job.
I thought once that I was able to pause it and then change the cutting pressure, then restart the job. I thought I did this from the control panel.


Does anybody know how to do this ??

Thanks
JT

 

[SuperSignsMP]

Its hard to remember, not being able to look at it. You should be able to just pause it, hit the condition button on the plotter ( it looks like a plotter knife) then I believe F1 is the pressure. Then ajust it with the up and down arrows.
Or you can take the blade holder and take a little bit if pressure off by turning the top off the blade holder counter clockwise. Then hit the pause button again.