Jv33 only printing from two nozzle

[Tmanna]

Change print head, slider board , head cables, same problem
any ideas

 

[Robert M]

Mimaki

Did you change the cap top and pump? If they are bad you won't draw ink into the head

 

[Tmanna]

Did you change the cap top and pump? If they are bad you won't draw ink into the head

Yes change the cap and pump, still only printing through two nozzles. The tech was able to pull ink through the head. Right now I am waiting on the long cable that goes from main board to slider board

 

[brightbanner]

Yes change the cap and pump, still only printing through two nozzles. The tech was able to pull ink through the head. Right now I am waiting on the long cable that goes from main board to slider board

Test print and find which color was lost, then change damper of this color.
If it is not work, change head cable and long cable.
If not work too, repair the slider board or main board.

Brent

 

[Tmanna]

Test print and find which color was lost, then change damper of this color.
If it is not work, change head cable and long cable.
If not work too, repair the slider board or main board.

Brent

THanks, I changed the dampers and slider board already. I am waiting on the long cable to come in, if that doesnt work then its unto the main board.