Life Times CR Motor

[Conor Knoxx]

whenever I start up / at the end of a print job - I get this error:
"Life Times [CR Motor]"
I just hit "Enter" and it clears...
I'm assuming this is in reference to the carriage motor...
but is it a built in timer, that I can reset somehow (because its working fine)
or do I actually need to replace the motor?

 

[Geshkin]

Actually, you have to check CR motor. No need to replace if working fine.
Just go to Maintenance mode and reset counter.

 

[brightbanner]

whenever I start up / at the end of a print job - I get this error:
"Life Times [CR Motor]"
I just hit "Enter" and it clears...
I'm assuming this is in reference to the carriage motor...
but is it a built in timer, that I can reset somehow (because its working fine)
or do I actually need to replace the motor?

The motor is OK.
Hit enter and initialize it under maintenance mode.

Brent

 

[Conor Knoxx]

thanks guys, I kind of suspected that.
I've never gotten into "maintenance mode"... guess its time to learn something new!