Discussion Mutoh 1624x

JustMe · Tuesday at 1:37 PM

Does anyone know why i get end of roll before printing starts. I've covered the sensor hole as well put some banner material around the sensor.

Ssignature · Tuesday at 7:06 PM

You need to recalibrate your rear edge sensor

JustMe · Tuesday at 9:15 PM

Ssignature can you tell me how to do that or tell me where to get the info about how to do that?

Ssignature · Tuesday at 10:15 PM

See attached PDF

JustMe · Wednesday at 9:39 AM

Ssignature, I went through the steps and now it won't read the material with. What can I do. And thank you for all your help.

Ssignature · Wednesday at 9:45 AM

Often the edge sensor gets ink on it. It is on the bottom of the carriage and reads across the black line. Clean it with 91% alcohol and a swab