Been using this plotter for about 9 years without hassles when all of a sudden it won't do the set up at all.
Cleaned all the sensors and inspected all contacts on the main board.
All i can think of is the programming has had a malfunction.
When I press setup (with material loaded the carriage will do its normal thing and travel the lenght but does not momentarily pause at the rollers to poll the material width.
Just goes to the end and the control panel lights keep blinking.
Have tried resetting the EERom by holding down left and right arrows as well as Origin button but still no good.
Any help would be appreciated
Cleaned all the sensors and inspected all contacts on the main board.
All i can think of is the programming has had a malfunction.
When I press setup (with material loaded the carriage will do its normal thing and travel the lenght but does not momentarily pause at the rollers to poll the material width.
Just goes to the end and the control panel lights keep blinking.
Have tried resetting the EERom by holding down left and right arrows as well as Origin button but still no good.
Any help would be appreciated
