Need Help Pop out stickers

[Pski89]

not sure the correct terminology to be using, but effectively I want to contour cut the sticker, then i believer it actually called perf cut a rectangle around the sticker, so that when the job is finished the stickers are basicly just handing onto the vinyl but the corners or something, so that I can just "pop" them out and be done.

Is this a setting in versaworks, flexi or is this some sort of custom setting people make. any advise would be helpfull

i have versa works, flexi and a Roland BN-20

Thanks!|!

 

[Boudica]

You'll need a cut layer for that in the artwork, name it FLEX_CUT. Then assign a spot color, with the exact same name. VW should recognize it.
Then there is a lot of fine tuning to dial in the perf cut just right.

 

[SignMeUpGraphics]

It's called PerfCutContour in Versaworks.

 

[Ltstickers]

Thanks so much for that insight, I will give it a look tomorrow