registering to back at start up

[signgal01]

I have a graphtect fC7000-75 that is a workhorse! I have had this problem twice and can't remember how to fix it. When I start up the machine and select roll1 to get the machine registered to the front right to start cutting it goes to the back of my roll and stops on the left side. I feel like it is just pushing the right buttons to fix it but can't remember.

Vicki Sign Gal

 

[Joe House]

When you load your media, you've accidentally set it to "Front Set" It happens all the time with that model. It's been too long since I've run one of those. Look before you lower the pinch wheels or right after. You should have the option to change that. I believe it was using the uip and down arrows to change from Front to Rear.

Good Luck

 

[signgal01]

Thanks! yes I figured it out hold the up and down key together at the first screen.
Vicki