Hello everyone I have a Roland sp300v and using Versaworks . I print my design , laminate it and set it up to cut. It finds the first registration mark the instead of moving across to the next it moves to the back reg same side seems to find that then starts to cut where ever it pleases ruining the design. and no i did not load it sideways because the design is 5ft long any ideas??
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
roland sp300v registration marks problem
- Thread starter Mikey42
- Start date
Team Valhalla
New Member
Are you laminating over the registration marks?
SP
SP
yes i am laminating over the marks
J Hill Designs
New Member
are youre outer wheels outside of the regmark dimensions?
phototec
New Member
Some on here have had issues with the sensor not being able to read the REGISTRATION marks when they are laminated, so try a TEST and keep lamination off the REGISTRATION marks.
Sometimes there is a reflection coming off the laminate (depending on lighting in the room), which causes the problem. You can cover the REGISTRATION marks with paper when laminating, making it easy to remove the laminate over the REGISTRATION marks.
Hope this helps......
