For the past several months we have had issues with our Roland TruVis VG2 and wrapping. After printing we let the material dry for a day or two then laminate. The vinyl would stick immediately to the vehicle and was difficult to reposition so it made wrapping tough. We are using Avery cast vinyl and lam.
I reached out to Roland and they suggested using Gen II profile instead of the Avery profile. This worked better but we are still having edges curl after the graphics have been printed. This makes it a little tougher to line up panels.
I never had these issues with my old Roland XC-540 printer. Roland says you can print, laminate and install immediately which I find hard to believe.
Anyone else having these issues or have any suggestions?
I reached out to Roland and they suggested using Gen II profile instead of the Avery profile. This worked better but we are still having edges curl after the graphics have been printed. This makes it a little tougher to line up panels.
I never had these issues with my old Roland XC-540 printer. Roland says you can print, laminate and install immediately which I find hard to believe.
Anyone else having these issues or have any suggestions?
