Signlab and Roland XC-540

[Lobo]

We recently upgraded to Signlab 8 and would like to use our XC-540 directly from Signlab, but I can't get them to talk.

In VersaWorks, the 540 is connected to 192.168.1.10, but that IP is not available in Signlab.
I can connect to a specified IP if I choose RAW, but then the port (probably) is wrong.

Any help is appreciated!

/Toby

 

[JR's]

if you just upgraded cadlink support can help you. I had a similar problem we ended up going with usb connexions. but thy walked me throe it .
good luck
JR

 

[Lobo]

Ok.
I really want to use the network though. I hate cables...