VP540 getting cranky.

[Gene@mpls]

So I have a TF640 sitting here in the box- just built the undercarriage and my old faithful VP is giving me a rash... jealousy maybe? Anyway it prints the
first reg marks fine and then the complete graphic and then starts the end reg marks and I get a scan motor error. Just changed the scan motor last week
because it was acting out sporatically and just today cleaned the linear encoder and it does the same thing again. I 'think' I have a spare LE- spose that is
the next step. It makes the first pass to the little angles before the reg marks and stops on the far side of the scan... I don't really believe it is the LE. Gene

 

[CS-SignSupply]

Is it throwing an 0090 error code?

 

[CS-SignSupply]

This could be wire tension, left side wire pulley bearing, linear rail bearing, motor, encoder, encoder sensor, servo board

 

[Gene@mpls]

Thanks Bobby- I think this printer has a drive belt but I will check out the rest. Gene

 

[Gene@mpls]

Is it throwing an 0090 error code?

It is a 0040 code Bobby. Thanks Gene

 

[qmr55]

May be worth a try.