• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by CodeHorror

  1.

    Need some information on the FFC socket in the CJV30-60

    Thank you so much netsol, that would be very helpful, and much appreciated.
  2.

    Need some information on the FFC socket in the CJV30-60

    I think that's it. I don't think 1mm are common and as I only need 1 they're probably not keeping stock around. Going to check newark and do some more digging around.
  3.

    Need some information on the FFC socket in the CJV30-60

    Tried mouser and farnells (similar site here in the UK) but they don't have the 1mm sockets.
  4.

    Need some information on the FFC socket in the CJV30-60

    Any idea where I can get these sockets? I ordered from 2 different places, were meant to be 1mm but they sent 0.5mm. I asked why and they said they don't stock the 1mm. I've got an idea where I can use that connector, and print a small breakout type board. I'd rather just get the replacement...
  5.

    Need some information on the FFC socket in the CJV30-60

    Yes. You can solder them too using the drag technique. Or solder the pins one by one if you've got a fine tip.
  6.

    Need some information on the FFC socket in the CJV30-60

    I found this, but it's not available with 1.0mm pitch, only 0.5mm. This looks to be the correct one though: https://uk.farnell.com/hirose-hrs/fh12-50s-0-5sva-54/connector-ffc-fpc-zif-50pos-0/dp/2564808
  7.

    Need some information on the FFC socket in the CJV30-60

    Hi all, I picked up a Mimaki CJV30-60 at auction. It was listed as faulty and I got it for a good price. I took her apart and noticed the FFC socket on the mainboard was broken. There was no clip to hold the cable it. Somebody had tried to desolder it and part of the plastic was melted with...
See more
Top