Recent content by crgraphics

I use this cutter from Vevor on the maxmetal panels...works great. https://www.vevor.com/paper-cutter-c_10879/corner-rounder-cutter-r6-r10-heavy-duty-commercial-cutting-30-mm-metal-for-books-p_010566173324

Well then Damon, point me to your website, or give me a quote for a scan and feed motors, and a pump...i'll start with those and see if i can replace them myself. Even if i cant do it, the techs down here in fl usually dont have the parts, or they say 3+ weeks. I usually order from digiprint...

Now I need a little advice...apart from the usual maintenance parts, what other parts should I be thinking about ordering for future issues. My printer is about 15 years old, and i would like to get a few more years out of it till retirement. Ive never replaced a pump, hose, motor, heater...

I'm rolling the Amazon chinese crap dice, and I'll let you know if they work...

That's exactly what I did, and all is working! Thanks everyone...saved $400 and a two week service call wait.

Trying to find some of these cable/shield fasteners for my SP-300V but having no luck...anyone know their official name or sku or where i can order them? Thanks!

Hah...did it...replaced the cable, works like a charm now! Thanks everyone for your help, wasn't sure if this was something I could handle without causing more problems, but once i took all the covers off, it didn't look too difficult.

ok, so i replaced the pinch roller sensor...but still getting the same errors...so i bought a cable, but not sure if its the correct one. Its from digiprint and the bag says CABLE CARD, 15P1 1900L BB SP-300 SKU:23475207 its 6 feet long by ⅝ inch wide...i was expecting a wider cable (see pict...

Just want to make sure i ordered/received the correct cable before i call for service. I bought this one from DigiPrint and never had issues with them before, but i expected this cable to be alot wider. The bag says...CABLE CARD, 15P1 1900L BB SP-300 SKU:23475207. The cable is 6 feet long by ⅝...

I've used zooprinting.com for many years, but switched to Sinalite for the pricing...still use zoo for direct mail tho

Thanks...now i just have to figure out how to install it!

any idea what the sensor is called? i found this one at digiprint... This Sensor-Interrupter GP2A25NJ is suitable for Roland AJ-1000 printers. This is the original Roland part (number 15099115). This sensor detects the width from the pinch rollers position.

Got an old sp-300v and i'm getting a left pinchroller error, or 0.0 for width, and it's becoming more frequent. I just changed the encoder strip and the encoder board, but that didnt fix the issue. After a few tries I can get the problem to clear up and resume printing. Any ideas? Thanks!