Recent content by S&S

Hi, Really not sure what caused the issue but it has now resolved itself. Thanks again for your help with this. All the best,

Hi Adam, I've had the printer around 5 months but it's a second user machine. The air purge doesn't seem to be fixing the issue unfortunately. I believe the company that I purchased the printer from replaced the cap when it was delivered to us. Do you have any other suggestions on things to try...

Hi Adam, Thank you very much for your reply and advise. I followed the instruction manual for the air purge and gave the caps an extra good clean but the issue is still happening. I'm not 100% sure that I have done the air purge correctly as I was expecting to the see the printer discharge...

Any advise would be very welcome. Have an issue with our JFX200. At the right and left of the print we are seeing some cyan streaks. If I run a print test I also can see some cyan on the yellow nozzles. We have soaking the heads with a nozzle was that helped but comes back again after one print...

Thanks for your Thanks for the advise. I tried to run the limit position setup but getting service code 0102 which I think is the head lock sensor error. Any suggestions. Not sure where this sensor is on the printer to check it.

Hi, First time poster here but wanted to know if anyone has any advice of experienced something similar. My SG-540 prints fine with the Cutting carriage and print Print-head carriage travelling together but when it comes to cutting after the print is finished the cutting carriage no longer...