• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Seal 62

    Europe

  3. Laminating Long Runs... Problems...

    Good morning, I have a SEAL Image 62 plus laminator, which lowers the rolls to laminate, but when I press the arrow to raise the rolls, they don't go up, only if I turn the machine off and on again... Does anyone know what the problem is??

  4. Seal 62

    Good morning, I have a SEAL Image 62 plus laminator, which lowers the rolls to laminate, but when I press the arrow to raise the rolls, they don't go up, only if I turn the machine off and on again... Does anyone know what the problem is??

  5. Help Rasterlink

    Thanks.

  6. Rasterlink

    Yes, I understand, I haven't adjusted it for some time, the 2 lines cannot be superimposed, I'll adjust it and see if it solves the problem, if not I'll reinstall the rasterlink. TKS

  7. Rasterlink

    It is in length not in width, 1 piece with 2000mm feed comes out with 2020mm.

  8. Problems in RasterLink 6 with PDF's

    Hi, I have a mimaki CJV-30, and I used Rasterlink... The prints started to come out bigger than the original files, for example: a job with 3000mm comes out with 3030mm... Does anyone know what to do to fix it?

  9. Rasterlink

    Hi, I have a mimaki CJV-30, and I used Rasterlink... The prints started to come out bigger than the original files, for example: a job with 3000mm comes out with 3030mm... Does anyone know what to do to fix it?

  10. Help Rasterlink

    It sometimes happens with tarpaulin the opposite, the work comes out with a smaller size than the original, but that is due to the weight of the material and I corrected the Feed, now it comes out with a longer length that had never happened...

  11. Help Rasterlink

    Hi, I have a mimaki CJV-30, and I used Rasterlink... The prints started to come out bigger than the original files, for example: a job with 3000mm comes out with 3030mm... Does anyone know what to do to fix it?
Top