• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Graphtec feed speed while cutting

A

Aleck283

New Member
Does anyone know if there is a way to slow down the feed speed in between the cuts while cutting? Say it finishes a cut at the 14" point, then starts the next cut at the 28" point. looking to slow it down as it moves to the next cut. We cut quite a bit of PPF, and it likes to stick to itself, and the speed between cuts is too fast to catch it sometimes. i have looked through all the settings and cant seem to find anything. i set the "feed speed" to slow, but it didnt seem to change anything. graphtec 8600 130
 
You must log in or register to reply here.
Top