Recent content by Alexandre Carinhas

Jim thanks alot for your support, you've been amazing. Finaly I was able to solve it with your suggestion, very easy after you pointing the right path. The carriadge was higher on one side.

Jim, do you know where can I find those flat shim plates with 2,2mm thickness? Does Roland has something like this for the initial setup of the printers?

Thanks Jim. I will only be able to work on the printer this friday but that seems to be what I need to do. I will confirm it and then get back to you.

Yes, that's the scratch, but all the wiper part touches the base of the carriadge. I looked over and over and can't find anything sticking out in that area. And it's marked also bellow the head carriadge(I just can't take a picture of it but it's a straight line running all the lenght). This...

I didn't found any adjustments on the wiper assembly I think it's the flexibiliy of the wipers itself that take care of the hight diference when cleaning.

Hi, yes. I pulled all the way forward. But it's there that's hitting as you can see on the scratch marks. But I cannot lower it more or advance it that's why I thought it was possible to further adjust the head carriadge hight. If it's not, I don't know what else to do. Anyway thanks alot for...

Hi, yes, I took it off to clean it and took care of puting everything in the right place. It seems high because of the picture angle but it's not, I've checked it again after your message. Do you know what this screws serve to in the head carriadge? There's two on each side, and it seems to...

I already push it all the way to the front, but still the same.

HP115 it's around 11000 € here in europe from what I found out

Ok, I will test that thanks. It seemed it was in a fixed position so I didn't try that. Just tryed to raise the head carriadge but it doesn't seem to be possile. I will get back after trying your sugestion

I understand it's risky, but my engineer background and not design making the eventually bad decisions as I also like the challenge of recovering things. Let's see, I invested the 5000 € not 500€...didn't know there was Latex printers from a good brand at this cost. This is a work horse, old but...

Hi, my head carriadge of the XC-540 on the Low position is scratching on the bottom in a metal from the wipers system. Far from the heads but anyhow still scratching and making it to slow. Besides changing it to the high position that it stops the scratching how can I raize it a little bit just...

I produce mainly internally in our two stores, so higher margins in t shirts....but that's the idea of entering also the digital wide format, our business works mainly on the summer months and we want an activity also for the winter months leveraging the investment. You spoke of other cheaper...

Hi all, just to introduce myself, I'm Alex and I own a surfschool/Surfcamp/Surfshop in Peniche/Portugal. I've been doing some T-shirts and Sweat shirts with a DTG printer Epson F2000 which always gives me a bit of headheak. So if the was not enough I bought a Roland XC-540 in not functioning...