Recent content by AutoGraphx

Thank you very much Fred, that's it.

Thanks for the replies. Sorry it was so small. First time posting. I have made it larger. Unfortunately it was not Futura Bold

Can anyone help name these 2 fonts. Much appreciated.

CJ 500 Contour Cut This may not help unless a Roland tech reads. The Roland tech that looked at mine found an internal setting that was wrong. Where it read : 00000000, it should have been something like : 000000100. After he changed it it detected the registration marks and worked fine. I...

Home Depot sells 1/4" wide roll of green velcro for holding up tomatoes. I just cut it into lengths to go around the roll.

You may be able to make use of a product used to check bearing crush on engines. It's called "Plastigage" you can get it at your auto parts store for a couple of dollars. It's a very thin strip of putty. When you put it under the bearing cap and torque it down it is squashed out a little...

I get those same "pimples" using a different brand of laminate with a Big Squeegee. I figured I was doing something wrong. I was covering a 2'x3' print the other week and halfway thru applying the laminate I saw a small fly on it. I stopped to pick it off and realized it was between the laminate...

It sounds like the vinyl is not being started perfectly square. It probably will run straight if you are using a full roll of vinyl but if you are using a few yards at a time you have to make sure to start it off square. Put some tape with a reference mark in front and to the side of the pinch...

69 Camaro, 396, 400TH, 12 bolt posi. Owned it since 1977 and has been thru many reincarnations. I parked it 20+ years ago when I bought a 69 Camaro Pace car. I only just refinished it and drove it again last July. The Pace car is long gone now.

I purchased the download version for $348 on this side of the border. No where on the web site did it mention you didn't get the clip art & fonts. The box version cost the same and is shipped with the clip art/font disc. I thought I had read that you would access the clip art online with the...

Esx500 It is a CJ500 converted. The menu screen now shows as an SC500. I have one that I purchased a few years ago from Allgraphics Supplies in the Toronto area. It prints nice but is a little on the slow side.

I have yet to post or reply to a thread. I just sit back and read them. This is one that I will reply to and just say it brought a big smile to my face to read the latest update on Joe. Fantastic news!