Recent content by Camn

Thank you very much for the input. I will start there. It has been a few years since the clutch has been replaced.

I've attached a video of what my edge fx just started doing. It'll spit out the vinyl crooked, and the foil makes a slapping noise when doing so. The foil will also crease. After a few feet the vinyl will jam up. Things I've checked: -Vinyl feeds through just fine when spun manually -Punch...

My Edge FX will not connect to a network. When I turn the printer on it says "Can't connect to DHCP server". I've hooked the printer directly to a router and tried several different cables and the problem persists. All my other devices connect to the network just fine. Any ideas?

Thanks for the replies guys! I was able to correct the stepping by rotating the graphic just right and it eliminated 90% of the steps. It seems as if it's just a limitation of the printer.

Following up on this issue...I've been printing during the last year and the issue has mostly gone away until this week. It seems on certain jobs it'll come back. I'm exporting the files as AI vectors, so that's not the issue as many have stated. I'm not sure if these rough edges are just a...

Thank you Julie, I have made sure the hold down bar is lowered.

Thanks so much! My speed was 3.0, acceleration .20, force 13.0. Using a 60 degree blade. I cut a sheet without laminate and the cuts still drifted off center towards the end. I did try two passes and lower force and it helped with the corners, it's much better now. Thanks for the tip on that...

Yes, repeats are done in GSPPlot.

I have an Gerber Envision 375 that has recently acted up. Been working great for the last 6 months but today the cut alignment is off as the cuts move towards the left. The first cut (first image attached) is perfect, but as the cuts progress towards the left of the sheet they get off center and...

Thanks for your input guys. I am printing vector designs, exported at 300dpi. Also printing with spot coloring. The decal I'm printing is 1 inch tall, so it's a pretty small print. I've tried rotating the image slightly, it helps some of the lines but then other lines become jagged. Here's...

I've been printing with a Gerber Edge FX for a few months now and I've been curious if there's something I can do to improve the quality of the prints. Some of the lines get jagged, no matter the quality I'm printing at. I mostly print at 1200 dpi, but this job has been especially bad with the...