Recent content by CustomPlanetC

trying everything to fix the issue but no matter what we do the cutline is basically moving in whichever direction it wants to and this includes both service mode/ print-cut adj (regular)/ and calibration. anyone have any tricks or fixes for this issue?

No. :( I tried downloading the driver from the web site, but it always has issues when I try to install it. I figured if it was showing up in device manager under the correct name I was golden. I am now guessing that was an incorrect assumption?

I am using peck 6. I have not tried to push parameters, since I was unable to pull them from the previous board. I had to replace it because it was not communicating with the pc anymore. We had an electrician doing of some work and it seems to me there was a surge of some sort and it blew the...

I swapped it on my own at first but I do have a tech manual now. I do the button combination when turning main power main power on then press enter to have it say waiting so that I am able to push the firmware. This is the only mode where the computer sees the device in device manager. And I am...

Hey, so I installed a new motherboard onto my sp-300v versacamm and I am getting a sum error. I installed a new battery, downloaded the firmware, and even obtained the peck (peck6) tool to send the firmware over to the printer. I boot into the update push mode, but when it goes to push the...

Custom Apparel Creation