• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by CYPSIGNS

  1. issue with cutting master 2

    Also... the Registration marks tool works by the way, only the cut/plot part doesn't.

  2. issue with cutting master 2

    that is just what it said for the error, not sure why.... I installed it into the default directory and didn't change settings. If I cant make it work, I hope CorelDRAW will give me a refund on their software :(

  3. issue with cutting master 2

    it is v2 1.71 its the new one for corelDraw X5

  4. issue with cutting master 2

    Hi everyone, i downloaded Cutting master 2 today for corel x5 from the graphtec website. my problem is that when i try to run it in corel draw i get the following error message: --------------------------- CorelDRAW X5 --------------------------- Failed to load c:\Program...

  5. Fc4100-75

    Hello, I have a Graphtech FC 4100-75 plotter. does anyone know where a good place to sell it would be. i want to sell it as parts. because it misses small segments in cuts. i thought about ebay but i want to target a more dense population of people interested. thanks

  6. Graphtech fc 8000-75 question

    ok, I got it to stop changing my condition #, now i can't figure out why it changes my speed from 40 to 50. any one have any ideas??? thanks

  7. Graphtech fc 8000-75 question

    it is. this plotter is brand new.. i have only changed the condition 1 name, and the force to 40 from 30.

  8. Graphtech fc 8000-75 question

    Hello, my Graphtech fc 8000-75 is switching to Condition 2 after it cuts.. is there a way to set a default, or keep it from changeing. Im using the USB connection and windows xp and flexisign 8 Pro. thanks

  9. Cutting Pro FC4100-75, makes loud hard click noises

    Ok, yes, on mine there is a 1/8" rod that is vertical, and that rod is inbetween 2 bearings. the bearings keep the correct angle, and alignment of the moving parts. I oiled it earlier today.

  10. Cutting Pro FC4100-75, makes loud hard click noises

    Has anyone else oiled that... it moves very smooth, and im not sure im supossed to put oil on the coiled wires inside there.

  11. Cutting Pro FC4100-75, makes loud hard click noises

    Hello, thanks for the reply... yes it is secure, it also does it with the pen attachment.

  12. Cutting Pro FC4100-75, makes loud hard click noises

    Hello, I have a graphtech Cutting Pro FC4100-75. when ever the blade moves up and down it makes a terrible loud hard clicking noise. it causes the blade to miss about a 1/16" of the cut making weeding very very hard. It has not always been like this, it just has gotten really bad the last few...
See more
Top