Recent content by Devcnc

glad to hear its fixed ish

did you try cleaning your machine??

VHB tape would that work on dibond and 6mm Acrylic for a office sign?. we did one with 3m tape and the 6mm Acrylic fell off 3 days after it was installed . or some type of glue hope we don't get anymore of these haha .

is that 1000 - 15000 ipm or a metric. MM

yes sir .1875 climb cut 16000 @ 40 FR. really would like 100 fr hahaha seriously its just recently that the zippering has started I use a Onsrud 63-614 first on 080 then finish it off on ACM

no i have a MDF wasteboard with vacuum table I can't use lube plus we have vinyl signage ontop our machine is getting upgraded and were adding an air mister that might help . its the zippering of the edge

I use climb and a .1875 bit been using this for 5 /6 years specifically Onsrud 63-614 once the bit is finished with the 080 it moves over to ACM, I average about 60 or more signs a day when cutting 080 and about the same or more with ACM with the same bit. its just been recently that the 080 has...

cool ive been using a .1875/ 3/16 bit for years and this just started to happen . I cut up to 60 pieces of aluminum a day and that takes all day. i use the bit from aluminum for ACM when it starts to wear out then up to 20 sheets of ACM. like I said the zippering is a recent development. ill...

lol it is a new bit

Hey all, just wondering if anyone has come across this and what was your solution. i cut 080 aluminum sheet and ACM with Sign Vinyl lately ive been getting a zippered edge on both products played with feeds and speeds but i cant seem to have them gone. Has anyone encountered this before?? Axyz...

you could try 10mm Coroplast depending on the size of sign just make feet or if you want to git fancy try 10 mm Acrylic that would look nice and its heavier . just my 2 cents