Recent content by idchad

Found out the streaking problem was not enough oil on the head bar. It was catching enough to cause it to streak.

I got ink to the heads i found out the top cap where the hose connects was not tight enough and you would think being new it would have had a good seal. Now trying to figure out the streaking problem will try to get out a picture posted.

also the manifolds are new they came with the print heads,i also tried to pull ink threw the head connecting a syringe to the bottom of the top cap while docked.

all heads were working but had dead spots in them and when you printed a image the image would have 1/4 streaks running through the whole design. So i got new heads, new top caps, new dampers, and 2 heads work but the other 2 can't get ink to the heads. if you print a design with the 2 colors...

Bought new heads and top caps for all 4 heads but only the black and magenta work. The cyan and yellow are not getting ink. Pulled the ink to the dampers and got it to fill and then tried to pull it from the back threw the head but no luck. Did a ink fill did not work. Any ideas on how to get...