Recent content by IN-WondeR

That´s probably not gonna work here in Denmark. Don´t think I can get that much of a new machine here i Denmark. :) Things work a little different here I think.

How much else needs to be changed but the addition of heat and new tubes for the heads in order for it to print with solvent? I really can’t see what else really is needed. Granted the original heads might not last long with solvent ink. But I can always add new head which are prepared for...

Paid $150 for it... So I´m good. :) I wonder how much it would cost to convert it if possible... Heating strips can be bought for little money, I need a control board, and something to turn the temperature up and down. I have ordered new ink lines, and dampers. Those were $44 so again little...

Just pulled the outfeed front of the machine, I don´t think there´s a heater there... Not sure how it would look.

I haven´t pullet it apart enough to see if there´s a media heater built into it yet.

It says CJ-500 on the label on the back. So I would think it is a CJ-500 And the front of the machine also says CammJet, the Display says SC-500 when it boots though.

All the ink tubes, and the dampers seems to be blocked, so I have ordered new ones for it. I will figure out afterwards if I need new heads as well...

I have just bought a used CJ-500 which in the display says E-sol MAX when booting up. Does this mean it´s been converted to run on Eco Solvent ink rather than Aqueous ink? I was thinking of doing the conversion myself. But if it already has been done then that would just be great. :) I´m not...