• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by joelswork

  1. HP Latex printing on Chrome???

    Hey guys, just wondering if there is a printable chrome that will work with the HP. I've seen various sites saying maybe Griff Decorative series but the roll I have was a no go with the heat needed to cure the ink.

  2. Importing Vinyl From China

    Just a couple points on this: 1: I know the toll on a business when adhesive goes bad. I know the fights some of these other guys have had with manufacturers to have bad product replaced. I also know the cost of refinishing a floor. One bad reaction with the adhesive and the floor finish and...

  3. Printer for Canvas Art

    Just wondering if you found the framing kits or if you had a picture... my wife is looking as well.

  4. Driver that works with HP branded summa cutter from print and cut combo

    Awesome! Thanks

  5. Driver that works with HP branded summa cutter from print and cut combo

    Hey guys, I currently don't need my HP cutter as I have 3 others now that work flow much better. My question is, is there a driver that will work with the HP other than having to run it through flexi? Summa Winplot doesn't recognize it but I can see it in Summa Cutter control but I can't...

  6. Night Bright reflective on hp latex

    Thanks for the feedback. I got a roll on order to try.

  7. Night Bright reflective on hp latex

    Just trying to decide if I should try this or wait for some 5100 to get back in stock. Looking to see if anyone has any experience with it. https://www.nglantz.com/2241821/Product/Night_Bright_NB48X24

  8. flexi production and summa registration marks not lining up (grimco holographic)

    I ended up digging through some old stuff and found the summa yellow opos covers. I put those on and it reads fine.... weird

  9. flexi production and summa registration marks not lining up (grimco holographic)

    production manager 21 printed on hp latex 115

  10. flexi production and summa registration marks not lining up (grimco holographic)

    hey guys, is there a way to manually set the marks on a Summa S2 T series with flexi? It's a weird situation where it will read the marks and do the cuts directly after print but if it cools off, it wont. I have enough bleed that I was hoping to manually set the registration marks but I don't...
  11.

    Flexi issue with plotter offset

    The tangential cutter did do much better but still noticeable… I’ll give it a go at at a bit bigger radius to see if that helps. Thanks for the input!
  12.

    Flexi issue with plotter offset

    So I talked to a flexi agent for quite a while today and thought we had it, but we didn’t. Squares work, the plotter offset was perfect on tests, calibrated both media and OPOS, X&Y axis were spot on. Then we went into production manager and into plotter settings and thought we had it when we...
  13.

    Flexi issue with plotter offset

    Hey guys, This is driving me nuts. I have my artwork done and put a cut box around it with a .02 radius on the corners. Everything looks perfect and checks out but when I open in in production manager and then send it to the plotter (hp branded summa, then again to my big summa T series) the...

  14. Ram TRX ignition color match... anyone know anything close

  15. Ram TRX ignition color match... anyone know anything close

    I’m actually looking for the ignition orange color…
See more
Top