• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by K_Ike

  1. Need Help Summa S160 T OPOS Tracking Issue

    I have recently done an OPOS calibration but will do another to make sure that's not the issue. It's cutting the circles roughly 1/4" down and to the right After cleaning the pinch rollers I was able to get it down to about 1/8" down and dead center on the right to left. I then performed a...

  2. Need Help Summa S160 T OPOS Tracking Issue

    So here's the pre-information needed before the issue. I have 3 Summa Cutters, 1x Summa S 160 T and 2x Summa S2 160 T. I call the Summa S160 T "Gimpy" because it's older and has... random issues. The software I use with these machines is a combination of adobe illustrator and winplot. I have a...
    • K_Ike
    • Thread
    • Replies: 4
    • Forum: Summa
See more
Top