I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Head surface looks horrible but you do have most of your nozzles on your test print. Try lowering the carriage to the low position and then re-run drop.pos. Then run a file using un-directional. Let us know what that looks like!
If you put CP manager in service mode you can use the Actuator menu in order to run ink back to the cartridge. This will Lower the ink level in the subtank and remove the error code.
It may be time to replace or cap and pump on that channel. Ink doesn’t appear to be pulling as it should.
The product code for the degassing module on a JFX500 is:
(MP-M801432 Degassing module)
If you are referring to the ones in the external ink supply box. There are 16 of them.
If you haven’t replaced the dampers in two years you might want to start there. Before replacement of a print head try replacing the dampers and the cap. Like you said you need to replace either way and if it’s a damper issue you save yourself the cost of a printhead.
This error means the light quality of the emitter LED is deteriorating or dirty.
In the NCU there is a light emitter LED and a receiver. The printer checks for missing nozzles by dropping nozzles through the NCU and tracking the amount that cross the light.
The NCU unit is located to the left...
What firmware version do you have on your CJV150? I believe that issue was fixed in one of the updated versions.
email : Service@reecesupply.net for onsite service request, phone tech support or parts/supplies purchase.
Onyx Or Flexi would be great if you have a couple thousand dollars laying around! Or if you want a monthly subscription payment. I wouldn’t spend that much just to run a 5 or 6 year old Mimaki CJV30.
Rasterlink 6 Plus would do the job just fine at a reasonable price. Unless you are looking for...
Along with everything said above you may want to make sure the “OverCut” function is turned on. (0.03 or 0.07) That should help with your “Attached in the corner” issue.
If you are looking for an affordable RIP software I would recommend Rasterlink 6 plus. The software is about $360 and it’s made by Mimaki to run their printers. You can visit there website to download the printer driver and the software. Keep in mind without the purchase of the software you...
The Mimaki UCJV150 or 300 series would be a great choice. Since you already have a CJV150 solvent the learning curve would be greatly reduced operating and software wise.
The UCJV series eliminates drying time with its UV LED curable system. Your ink cost per square foot would basically be cut...
This normally happens if the blade holder rubs up against the uncured ink on the media while cutting.
There is a option in Rasterlink that allows you to cut first then print. Click on the “Composition” tab and drop the “Cut” File to the bottom.This tells the printer to cut first.
With this...
Means the main board and slider board are not communicating. Check FFC cable between the main board and slider board.
Make sure the FFC cable is seated correctly. (Reseat) Other possibilities could be faulty slider boards or main board.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.