I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Digital Mags - Not always trouble
Mags WILL be a royal pain to run through a print/cut IF the weight is too high (stock too thick).
Don't run anything higher than the .15- to .20mil range. If you're doing truck mags, and you're not running them through the Gerber, you'll have to go with the...
ROLAND XC-540 - CAP TOP PRIME/REPLACE - PROTECED SERVICE MODE
Does anyone have options for dealing with an XC-540 'Service Mode Protected' ?? I've tried an interesting key combination I found in a thread a while back only to have the system politely tell me 'tough Twinkies...your still not...
It sounds like you may be working with 3M Dual Lock. Pretty sure there are different grades/types to accomodate various loads. Good stuff; sharp edges.
Don't laugh, but
Was the Firmware/Default Settings updated/reset at any point before hardware changes were made? (Like I said, don't laugh but....you never know)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.