Recent content by Mike Paul

Yes it’s available but crap unless you just need it for a year or so

Can check with Stahls too.

Premium sign supply in PA. They are quick but if you buy a $60 cleaning cartridge shipping will be + $23 for ups ground……

That’s a lot of calculations. Lol. Do you have the cut off in house? Probably.. $375

VersaWorks is perfect for that printer. I design in Flexi but print from Versaworks. Try making the change.

It’s a baby banner. Go to yours local dollar store and purchase a 4 pack lol for a dollar or two

bungee cords if you have grommets. That banner is small. Keeps it nice and tight. And will flex with the wind…

Outsource those, Not worth a head strike.

Roland spot colors don’t work with gradients. My tech / installer made a couple changes in Versaworks when I got my new printer last summer. Great gradients, no green grays to try to overcome. I’ll try to post tomorrow with the settings

No one that I know of. Ran into that same problem like 20 years ago. Some engineer sent me specs for an over a road banner for a Fourth of July party. Wanted reinforced sewn in ropes, grommets every two feet, wind slits that had to be sewn around the perimeters so not to rip. No thanks

Try a new blade, the tip might be broken. Doesn’t matter if it’s a few weeks old. Make sure the blade hold is seated correctly and the screw is tight. It’s an old machine so could be just wear and tear on other parts…

Try a little silicone spray?

That piece looks like 6-8 inches unless your talking about the hood.. Slap it on there and tell them not sure with the texture. I’d Cut them a couple extra little 6 in strips for free and give it to them in case it craps out in a year after they run it through a car wash…

Flexi and Photoshop

Mine did the same sometimes. Just ran a couple inches of a CMYK strip beforehand then it clears up. Didn’t seem worth a service call…