I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Tekkie,
It sounds not very convincing as the pipe from the water tank links to the UV lamp. And you can find in the USER MANUAL that "When only water is supplied to the cooling water tank without antifreeze liquid, it may damage the UV
unit by freeze." I am quite sure the anti freeze liquid are...
Thank God!! I solve the water lack problem by changing the anti freeze again. After that I tried print once but the machine still stop because of UV unit overheat. I wait a while between printing each layer and finally i can finish my printing jobs.
The print head comes with a recover system...
Oh my god, the distributor asked for USD$250 for only the maintenance fee (i am afraid it is only a look at the machine). I decide to change the liquid again and check if the pump work properly. I will report you guys after this check. Wish me luck.
Thank you very much for your comment
ideally I will ask a technician to visit workshop for testing.
hope the most expensive parts do not need to change.
And anybody have an idea about the working life of the UV LED unit
the distributor said a 2 year old LED is old enough to change. Any comment...
Hi guys,
I have been using a second handed UJF-3042FX for a year (2 year-old in total). last week it stopped suddenly showing that the UV unit was overheat and I switched off the machine. It comes again when I start over the printing jobs.
1 week after, the same problem occurred and it comes...
Mine is UJF-3042FX.
Normally I see this message when I press the emergency button. I am not sure if you have the same case as mine. Just see if you have accidentally pressed this button. Hope it helps. Good luck.
Hi Guys,
My UJF-3042FX suddenly display "Water lack" when I was printing yesterday. I followed the user manual to replace the antifreeze liquid but the problem still occur.
I am wondering if any of you have experienced the same problem. Now I totally cannot work with the machine. Anyone can...
i am not very sure if my way works.
I used to use the Lego bricks to assemble the fixture for different kind of items (like cell phone cases)
as the lego bricks have it spacing already. I then use the set the spacing in Rasterlink 5 according to the position of the case itself. Somehow you may...
Hi Guys,
I just found that the C M and K ink has just expired but i just used less than half of them. Anyone has tried using an expired ink? Will anything goes wrong with the it? Anyone has tried to use the 3rd party ink as well? Is it good and would it ruin the printing head? Thanks in advance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.