I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Any tips on where the best place to sell equipment is? I have a SP540V as well as a brand new top heat laminator ... and a heat press and hat press. Any advice would be appreciated.
the laminate was sticky side down on the bottom roller. Never had an issue before but this sat for awhile in a fairly warm room. No knife needed. I peeled it up off the roller and chunks of rubber came with it. And I mean bad. Can't even tell you how stuck it was on the roller. Didn't think...
Hey all! First time poster....long time lurker. I'm a rookie at the vinyl graphics but getting better. Been out of town for a while... came back last night to laminate some print jobs and about a 2" section of lam had stuck to the bottom roller of my laminator. Hindsight says I should have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.