Recent content by sekorse

Hi, do you know how to switch back to max2 ink, as I'm still having yellow problems despite changing all the parts... and I still have max 3 cartridges installed for the moment.

Yes always, to tell the truth the Max2 is out of stock in France... I don't know if it will come back.

It worked for 2 meters, then the yellow completely disappeared for 15cm, then came back little by little...

I also tried soaking the head overnight before cleaning this morning.

Hello, I've cleaned up but there aren't many more nozzles, some disappear, some appear, I tried a yellow print and the beginning didn't print for 4cm, then the yellow appeared but still with lines due to the missing nozzles...

Hello, after changing the captop I still have the same problem, I do not understand where it can come from everything is new.

Thanks I'll try to install the cap top... and the pump anyway I received broken I just saw that an ink inlet is broken

Hello, I just installed OEM dampers, for the moment the yellow is back to 75% (I have the left line half empty), despite several cleanings it does not change anything ... I have a new OEM cap top and a non-OEM pump here do you think I should install them?

Thank you, And do you have a tip for finding out if there's still an air leak in the duct, please? Thanks

Hello, I ordered OEM dampers and a new OEM cap top, do you have any advice before installation? Thanks

Hello, after checking with DIGIPRINT, they confirmed that the cap top of the kit is OEM and not a generic.

Yes cap looks OEM, it comes from the digiprint 6 month maintenance kit. I have a new pump included in the kit too but I haven't installed it, and it's not OEM, for the moment I still have the original one it's never been replaced.

Hello, I'm on my 3rd different cartridge from different suppliers (new), and the problem persists, although I've never had this problem before and I've always used EcoSol Max3.

The ink needle doesn't seem to be faulty, and the ink circuit is completely new from the cartridge to the printhead.

I even tried to make a Choke CL with the roland service technician software. This is recommended in the technician's manual when a color is missing due to air bubbles.