Recent content by SheldonDay

They are seated correctly, as far as I know everything for these comes from China, if you know of some that don't and have had good experiences, please by all means let me know where and I'll order there. I change them out which is recommended every six months and clean them once a week as the...

Updated 10/20/20, the last time was very helpful, I've been having trouble with the MG/Yellow cap top. After having printing issues, I replaced both cap tops and all was working very well. Have done Weekly cleaning and a Heavy cleaning on the printer at least once every week. For some reason...

Ok guys, your the experts, and last time was very helpful, I've been having trouble with the MG/Yellow cap top. After having printing issues, I replaced both cap tops and all was working very well. Have done Weekly cleaning and a Heavy cleaning on the printer at least once every week. For...

I am replacing the cap tops, I can pretty much say they probably have never been replaced so I'm going to start there, run another nozzle check just to be safe and more than likely replace print heads at that point. Another problem I'm having if anyone can help is how to print, laminate and...

I do not recall any event of that nature. This thing has probably never been serviced. I was instructed to take over this part of the business and right now I'm having print, cut, laminate and re cutting issues (probably print, laminate and cut issues sorry) as well. I'm new to this so pretty...

Here is it. This is after two cleanings, it is better but still bad. Are the Red and Yellow supposed to be the same and the blue and black? If so is it a bad printhead?

Ok cleaned the head, wipers and all the needed stuff. Let's see how that does! I will let you know and post a new nozzle test later.

Ok thank you, is there a video for that? or do I have to get cartridges to do this. Never have done this so bare with me please.

Here is the nozzle test. I'm new at this so I don't know a whole lot about the Roland Printers but learning as I go along. There is a small wrinkle in the 3m paper on the right hand side area so disregard that please.

I use a Roland Versacamm SP-540i, versa works software and AI for the software. Reds are printing Pink and Blues are printing green. Have tried almost all the fixes that they say they are and still no luck, does anyone out there have this same problem. Printer has been excellent and all of a...