Recent content by teethree

Thanks guys! I adjusted the tensions and checked the balance on the rolls, the right side was up too high, which also made for a problem with tracking, she now laminates like a dream, Top it off I made a quick-change roll holder to transfer media and rolls directly from our Hp-L25500 to the...

Had a couple issues with a brand new laminator (vt-9600) we've only had for a few months, most of them we have figured out but this last one is a new issue. When laminating prints we get a media bunching up in the center situation, about 8-10 feet in, it starts with the media going in getting...

Signcomp is what you're looking for if I am correct.

Hello! Figured I would try and hit all three birds with one stone here. I working at a company that I have been absent from for about a year and came back to a slew of problems with the graphtec machine, seems she got pretty beat up while i was gone, by what seems to have been either wear and...

Here i thought the cutter was the issue! Jeeze, the media had a crease in the middle of the roll it looked like but i didnt think that would matter much, but it sure was enough, time for a free roll and peace of mind :) Printable Thermoflex shouldn't come with thin backers, guess thats my lesson...

Belt may be the issue =/ pulleys are also not cracked tension levers are in correct settings its the same on both cut and printed vinyl across all media types so it can't be material. Printer is HPl25500 Onyx 11 postershop, using cut server. Going to get a force gauge to double check the belt...

I tried to look it up for a few days now, but it seems my graphtec is slightly sagging its cut path in the middle of the page, fc-7000. It cuts fine at the left and right most sections of the page but there is a large offset in the middle, about a 16th of an inch, for example, if i were to cut 3...