• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Terry01

  1. Roland Pro 3 XC 540 Print head

    You need 2 DX4 heads. Use genuine heads only.
  2. Roland Pro 3 XC 540 Black and yellow not printing correctly

    Remove the Lc and Lm heads and swap them in the black and yellow positions. Do a realignment and use a cmyk icc profile when printing. Doing this will get you up and running and then look at replacing those two heads later. Alternatively replace the two heads now
  3. Roland tech and Roland dealer in my area

    What is the current problem with your printer?
  4. Fuzzy edge on print and thin magenta boarder, head alignment?

    Need to go into Service Mode and do a printhead alignment, bidirectional adjustment
  5. Side hustle to keep my printer busy during the slow months

    Lucrative business selling homing pigeons too, sold one 36 times so far..:cool:
  6. Banding / Printhead Issue?

    Have you performed a feed calibration?? Have you tried different inks?? Also looks like heat needs turning up to prevent pooling.
  7. Banding / Printhead Issue?

    As Jim stated, showing us the type of banding is what is required. Cyan is usually mixed with every other color, unless you are spot coloring with cyan only.. You will also never know when your icc profile uses Lc or Lm
  8. Banding / Printhead Issue?

    That slight deflection on one nozzle won't be causing noticeable banding. What temperatures are you running and is it only on certain materials?
  9. Need Help old ROLAND SP-300V problem

    Don't worry about the fill print being sticky. The heaters aren't turned on in service mode.
  10. Have to press PAUSE to start printing Versacmm SP-300 ?

    Pressing pause, overrides the warm up time of the printer heaters..
  11. SP-300V wrong colors on first job

    Check pump lines not blocked. Looks like cross contamination of Black cyan head. Run a clean cycle prior to print.
  12. Roland VS540 - banding/ color drop out

    If the banding is spaced evenly, the roll has been laid on its side, without the carriers in the ends. Try another roll and see if it persists.
  13. Mimaki JV33-160 problems after error 202

    Remove, clean and re seat printhead cables
  14. What kind of plotter will compliment roland vs 300i the best ?

    Spend more time setting up the cutter on the machine. Don't just do 1 test cut and think everything is ok.
  15. How to explain outsourcing?

    In sticky situations, ask the client if they get the service on their Toyota done in Japan, or down the road at one of their agents.?
Top