Recent content by theprintlabtx

Anyone know what font this is, TIA!

That was close, but not quite it. The e isn't connected so that's what I see that is different. I was able to figure it out though, it's Dessau Bold Thanks though!

Can anyone let me know what font this is? TIA!

Thanks you nailed it, it's a lowercase O and U it seems

Thanks in advance!

Roland XC-540 This is just a basic intermediate vinyl from grimco This is a test print from the versaworks software Ink is 20/20 ink from grimco The test print is pictured above which has a heavy presence of magenta

Hey everyone, I have a quick question and would appreciate any help you can provide. I got this printer used from my father in law. I ran a test print and the result is in the photo below. I have sorted out a profile that works around this issue mostly, but I would love to just fix it. Anyone...

Man you are good. Do you have a mind palace?

Hey guys, turning to the pros on here to help me ID this font! Thanks in advance.

Well it is with much relief and a dash of embarrassment, I write this to tell you the problem has been solved. I logged on this morning to read your reply and with a bit of desperation I walked to the printer seeking a last ditch effort. After considering the cable in the main board was oriented...

So at this point, I have replaced, the carriage cable, the sensor and the board and I am still getting the right pinch roller error. I am at a loss. Is there something that I am missing?

Thanks for the help. I tried putting something in front of it and sliding it in front of the pinch rollers and it never gave me the star. So I am assuming that means it's not working. Just to be sure, you are talking about the sensor in the circle on the attached right?

I did a sensor check and I got this. I looked it up and it says the media sensor wasn't on, but I didn't know if that meant it wasn't in use or it was broken. Did I read it right from what you know?

Yeah I disconnected those to pull the board out to swap the cable. I'm guessing there is no way to narrow it down a bit more so I don't end up buying more parts that don't need replacing is there? One thing I noticed is that the brief pause the carriage makes when it encounters the pinch rollers...

Hey Guys, So I have a Roland XC-540 second hand. A couple of weeks back started getting the issue where I would get pinch roller errors when I would setup new media. And occasionally getting the 0.0 width thing as well. I didn't think much about it, did a breif googling and didn't find much...