I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Ok here's what happened. I select the option ''off'' in full width scan.
Started to print, then WTF? Picture 1 ( looked like I ran out of ink)
Looking closer, the head printed all the way back to starting point even over the wiper!
So I restarted my print, then (picture 3) I got fuzzy spot...
Can anyone tell me how to set the printer to make sure the head only prints 30'' wide when I print on 30'' media?
Right now the head is going 54'' wide and time to print is way longer than if it would only go 30'' each pass.
Thanks,
Hey Mader Design,
I just saw your post on the forum, where you say you can sell the atv templates, I would like to know how much your are selling them? and how's the fit? I've tried templates with hunt earlier but was satisfied at all.
Please tell me what atv templates you have I would like...
Hey Flame,
Hope your doing good, I heard about you for motocross templates,I will need to get many of these soon. I would like to know how it works, if I need to buy a package or if I can buy one a the time. And I would also like to know if you have template for raptor 700 2008 and ktm quads...
Does anyone knows where I can get a package of motocross templates, I found pyromedia and hunt graphics
But does anyone could give me a feedback on wich one is better? or if you know somewhere else I can find them.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.