Recent content by Zaaniwoop

Yes please. Sp-300 and SP-300V rob@advasign.co.uk Many thanks

Ok. Latest update: I found and installed Versaworks version 2.4.0 on my laptop and it prints and cuts fine. I will stick with this version from now on until I come across any further pitfalls. Still don't know why later versions wont print and cut though.

Yep. Nothing works. I've tried all the above. Didn't have a problem until I updated VersaWorks a few years ago due to a reinstall. I've even tried installing VW on a laptop. Clean install. Same results. I've all but given up now and am looking at the prospect of buying a new printer.

Hi, Yes. I've had no luck with any VW settings. I've tried all the menus on the Versacamm. I've even checked on the SERVICE MENU. I've uninstalled and reinstalled software/drivers... Tried a new install on laptop which had no previous version of VW on it. Had the back of and cleaned motherboard...

Hi, Yes I have been through the loop trying to sort it out. It started happening when I performed an update on Versaworks. I restored my PC and the problem went away, but then a few years went by and I had to reinstall Versaworks. Ever since, I haven't been able to print and cut. I can cut. I...

Hi All, I have a problem with my SP-300v. It will print fine, but at the end of the print sequence, it wont return to the origin point and cut the job. I can print and cut using the print/cut crop marks but this requires me running and resetting the job twice. I've been at my wits end trying to...