Search results

The laser on the right hand side has probably moved slightly, it's very sensitive to movement. Open the right hand side cover and adjust the laser very slightly, hopefully this will do it.

Hi, No the heater or the lines are not even warm. It doesn’t seem to heating up at all.

I still have problems with my temps, I have installed a new pump , which is working fine and also installed a new water heater but this does not seem to be getting hot or even warm, there doesn't seem to be much air in the system , so any suggestions as to why the heater is not working, any help...

Hi, Your temperatures don't seem to bad, According to my Mimaki Engineer, Heads 1-4 should be around 48 degrees and the Hot water Temp should be around 60 degrees.. The heads on my printer were around 28-29 and water heater around 29. I have changed the coolant and taken air out as much as i...

Hi . I have the same problem as Biggady, on my Mimaki 6042 Mk II, which is nearly 3 years old i have drained the tank twice now and refilled with the correct 2-1 mixture of de-ionised water and anti-freeze but still get the same message 'Head Temp. Control Please Wait...'. I can override this...

Many thanks for your reply, if Anybody else has experience of this situation and can help, it would be much appreciated.

Hi, I hope someone can help I have had my Mimaki 6042 MK II About 34 months, everything was fine for the first 24 months ( in warranty ), then 3 days after the warranty expired i had a main PSB Go down and need replacing, also a slider board was changed at the same time. 6 months later the...

Hi, I have just had the same issue with my Mimaki 6042 mk ii, I got the keyboard board changed and all is good now, the new board comes with a display screen as well ,