• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Removing oxidation from vehicle after graphics removed?

    Try some vinegar. It might surprise you! It sure works well on sign faces.

  3. Another new member!!

    Welcome from OK Sign shows have some training available. Check with Beacon Graphics and see what they suggest. Good luck!

  4. Thanks for the Opportunity

    Welcome from OK

  5. Greetings

    Welcome from OK

  6. hello

    Welcome from OK

  7. Hello from NC

    Welcome from OK

  8. Hello from Florida !!!!!!

    Welcome from OK Use the cleaning fluid. Keeping your machine working and clean is not something you want to skimp on. That $80 gallon is about as cheep as you can go but it has limits. It should not be used in some places so read and follow the directions.

  9. Newb in Cali...Very Newb

    Welcome from OK to both of you! I'm pretty much in the same boat. My wife is confined to an electric wheel chair and has to have my help when she gets in a jam. You really need to get some lessons on composition. Your post would be more easily read if you started a new paragraph once in a...

  10. Newbeeee!

    Welcome from Lawton OK!

  11. HELP!!!! CX 24 Problem!

    This may be just a bump for you. The only thing I can think of is that the clamp roller is not positioned over the bottom roller. Since it moves in and out that may not be the problem but, it may have something to do with it

  12. GS6000 Epson = Mutoh?

    Welcome to the forum. Alcohol has been known to give people head aches but they still sell sell it for internal consumption..:Welcome::thread:wine-smi::toasting:

  13. Printing on Magnetic Roll stock?

    There is a special magnet material for printers. For the most part, the vinyl on magnetic vinyl is not a very good quality for printing. The heaters can't heat the magnet evenly enough do a decent job either. The magnet material also warps when heated so it is hard to avoid head strikes.

  14. Hi from wintery Cornwall

    Welcome from OK USA The trick to balancing the ball on your nose is to use banner hemming tape.

  15. New member looking for some help, Rockhopper 38"

    I never used more than 2 cleaning carts. Check your manual for cleaning instructions. They may have changed from what my mach was. Mutoh changes a lot.

  16. New member looking for some help, Rockhopper 38"

    I did mean the waste ink lines. The 3M stuff from fellers will work good for clean ups but follow the directions. Don't mix it with the ink that will be used for printing. Cleaning out the waste tubes should be no problem.

  17. New Guy-

    Welcome to the forum. This is a welcoming thread. Please introduce yourself in a separate tread and ask this sort of question in the appropriate forum. If you do a search, this question may have already been answered.

  18. New member looking for some help, Rockhopper 38"

    Welcome from OK. I have taken the lines out and cleaned them with solvent. Those clogged lines are an indicator that the machine was not used much. The next thing you will be concered about is the ink mixing in the head. Don't be too concerned with that until you get everything else up and...

  19. New Guy-

    Welcome from Lawton, OK.

  20. Laminate by varnish?

    Film laminates will last much longer and are faster & easier to apply.

  21. Solvent Printing on Static Clings

    The static does take more ink. I have printed on clear vinyl and stuck it to the cling material. Welcome neighbor, from Lawton, OK
Top