Search results

no worries.... "who let the chicken out?" lol

I don't use Summas (nothing against, just got a Graphtec in a bundle...), However, if it allows the Perf-cut option (or similar with different name...) you should be able to cut posters all but perfectly.... for our Graphtec I set the down for almost an inch, then up for .04" but this "up" us...

...."I need 200 double sided Coroplast Campaign Signs".... Are they not ALL double-sided? last time I looked for a single sided sheet of Coroplast I thought I was good, but every single sheet I turned over has a second side! darn 3d space makes the single-sided coroplast a very high improbability.

Dang! someone had to bring the Bowie....

interesting - I have not yet printed on the on the clearview, but I would think that the minimum vacuum needed to hold the media would be better than more... there used to be a product for guillotine cutter beds called Prisco Slide - this was a good silicone lubricant that you would wipe as...

oh, and I assume you guys have checked vacuum needed for this specific media (by running tests not from googling specs....) I have found when the media slips it can often be fixed by reducing the vacuum so it is just enough to keep media flat in the print zone. any more and it just causes more...

Why not attach the new media to a roll of old media on the take-up reel and then back up the media until the lead edge is barely past the print zone? make sure you have good heat resistant take to make to splice or you will have tape coming off in the curing zone.... but no need to waste more...

Our 700w came in with some intermittent connection problems with the printheads - fix was replacing the white ribbon cable that has the contacts to the printheads. But we would get intermittent firing like you are seeing.... it is obvious a printhead is bad, then it just starts working, then...

just curious, sorry, I don't use files with the fs extension... but why do you say you cannot edit the pdf? I have quite a few programs that will parse the pdf and edit...

For us we don't like the 'die-cut' portion of the sticker to be perf-cut... the rough edges and all, as well as the sticker can be difficult to remove from backing. However, we also have noticed that perf cutting is slower and we don't really like plotting twice. A compromise has been to set...

I have had this a few times.... if it was my 700 I would try a head cleaning first just to see if it changes, then if it helped, look at a new plot - then consider putting in a new optimizer print head. (for me the main clue is the plot is the worst on the optimizer, but any of the other...

just a few things, make sure your printheads are good, run a calibration, and make sure the original color has the correct profile - greys are very difficult, but you should be able to get a mix that has the correct color and prints clean. DO NOT TRUST CUSTOMER ARTWORK for printable colors -...

reboot everything and launch any "Barcode server"... and likely a hard re-boot, turn it off, clear the volitile memmory, let it come back then see.

And this one is a little early since they are letting us stay home tomorrow.....