Search results

find a wholesale to the trade printer to outsource - if they are still priced more than you can sell the things for, you are TOO CHEAP :thumb:

ITC Ziggy

i dont use the combo, but I have heard time and time again to not 'center on media' when doing print/lam/cut just a few pennies in the cup

tiffany or bodoni heavy/black/whatever both seem close

its up to city specifications as to need / not need wind slits/mesh

either laying down too much ink (profile related), wrong media (solvent vs waterbased), or contaminated media those are my first thoughts.

the good thing about the fsc is its a filler primer to seal up the open cells of the cut foam, and it sands beautifully

first clean both the linear encoder strip and sensor (it sits above the head carriage - a thin clear* plastic strip) clean it with iso alcohol the error gets sent when the machine is told to move in either the X or Y direction, but no change is detected from the encoder sensor(s)

futura BQ light and bold

top is possibly nuts

Ive always just used banner tape. what you CAN do is let it do most of the final pass, then mechanically fasten it to the the sacrificial board with screws/washers in the cut pass (I hope that makes sense) -- its my only workaround for difficult cuts and no vac hold-down

you can basically use anything. I use a roland traction plotter to do it, but of course sprocket is ideal for tracking

no match sorry

Zapfino Extra LT Pro (Regular)

customer install...thats what happened

+1 - if the material is tunneling between the rollers, loosening slack on the roll helps, as well as dropping pre-platen temp

so it cut the circle through the backing paper too? only thing I can think is trial version of software and an 'output limitation' /shrug

Candara Bold

if you view wireframe is the circle there?

crillee extra bold italic