Search results

Does it start to rotate during init? Prevent direct sunlight onto sensor. There is no specific position belt/sensor

Because in fact the ink is higher pigmented then in Gen3 you will need less ink to reach the same saturation. This will lead to less temperature to cure ink when running same productivity. With the 800w I can print on very heat-sensitive media, which was not possible before. White is really...

Between Z and Latex is a big difference, since the Z detects a broken bag inside the cartridge itself and latex only at the pip

What kind of ink u are using?

It’s an older Roland The cap tops are looking very used. The filter inside looks partially very swollen. I would suggest to replace them.

The part you’ve found is for sure not part of the printer. Regarding the issue, it could be dirty line sensor, encoder strip or a defective DD. Clean line sensor and encoder strip and do DD calibration.

Wipe particular with IPA and print onto. You will see immediately if plasticizers are the reason.

Offgassingtime unrolled. Regarding gamut I would not say so. But, halftone printers have bigger range to control colors. Contone printers like HP doesn‘t offer this functionality, but it’s easier to control colors in future. For halftone printers you need extra equipment and knowledge on color...

Purge is not not possible if supply is somewhere between 60-80%, no clue why. Use a new cartridge if you still want to purge tubes. And install old cartridge after purge is done.

There is no need to purge ink line, since there should be only a very small bubble of air in. TO prevent from this small bubble i insert the cartridge slightly and remove it when ink drips out ot the not-connected ink connector.

Which model you have? I remember in the past that on some machines the carriage bottom plate was not well isolated to machine ground, which caused this kind of static buildup. This affects also dirtiness of bottom plate. If this is the case, let a technician install the isolation.

They can be repaired since a long time. Repair kits are available from both FF and OCE. Mostly the actuator runs out of position and can’t move freely into opto-coupler.

Some stuff can still be accessed. But you need to have insider information. Someone who knows rfid-communication

And regarding car-wrapping UV inks are (mostly) less stretchable than latex and solvent based inks.

UV is a thick layer of ink which can’t be laminated without shadows. Latex can be laminated immediately. Solvent based inks needs time to evaporate all components and might affect stickiness of laminate.

If you’d like to print for indoor usage check out non smelling inks. Latex would fit. Outdoor non laminated go for UV. Small stickers with text go for eco-solvent. There is no machine that can do all at same time.

Rfid board is different between FF and OCE. Manufacturer is also stored on HDD, DataRelay and SystemControl pca. If one is replaced it gets the code of the two others. What do you need are two oce rfid pca, a backup of your registry, a registry of exact same Océ model and a data relay of exact...

Reset the CLC to factory valuesand redo it. Maybe database get corrupted.

In the log you’ve sent you can see lots of link errors to carriage. I would suggest to reseat both sides in carriage and behind the big cover where the ink filters are located. and clean the contacts with contact cleaner first. Check logs afterwards regarding carriage link errors.

Mistake: delete the color reference