Search results

S40 Print quality is great, ink yield is fantastic, dry time great, non warranty repair $2600 per visit, they just changed there repair policy and screw the consumer. buy and retain the warranty or run away. D1 does the repair work, good people but short staffed. Not sure I would get another...

I got the same question from farmers yesterday

You should be using cold lam and not heating the material at 119deg

Not bad stuff just use primer and edge tape, good for 3 plus years

Synology

Did someone open a door and allow a cold breeze in to the room? It will look like ink drop out but returns to normal shortly after door is closed

Graphtec is better, Summa is best

S60600

This started in Flexi 19 they have me upgrade to ver 20, 21, 21.1, 22 and 22.2 still 50% not getting last leg of crop mark. This has cost a lot of money in materials and time. They have been on my computer many times never resolved

Contact Northern Design Graphics in Seattle Has a DC4sx

Can this Epson Wide CMYK ver2 be applied in FlexiSign 10.5

Buy the clean cartridges and run per clean. Let sit over night and power clean 2 more times, pump dry and install your color cartridges. See how it prints, this should be done 1-2 times a year

Try heat settings- 35,35,50. If it still happens try 34,34,50 Good luck

Ungroup all parts before sending to cutter

Change it back to the way it was before you screwed it up

There are two common reasons for stepping, first is dirty encoder. Second reason is ribbon cable from carriage to main board

You can adjust the feed calibration

Temp memory is to large for a 32bit program, clear temp file or restart computer should fix the problem

Static Push or tape a Bounce fabric softner to the machice so it can just touch the backing paper, its magic and they work in the dryer for your cloths, who new!

file size Save it as a JPG and print